This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
icnd2:spanning-tree [2024/05/20 06:53] 114.119.138.183 old revision restored (2023/11/12 09:00) |
icnd2:spanning-tree [2024/05/20 11:27] (current) 114.119.149.71 old revision restored (2024/02/14 02:33) |
||
---|---|---|---|
Line 3: | Line 3: | ||
=====CONCEPT===== | =====CONCEPT===== | ||
- | * It does this with Each Switch broadcasting a **'' | + | * It does this with Each Switch broadcasting a **'' |
- | * Each SW will then determine a **'' | + | * Each SW will then determine a ROOT PORT, one per SW. A DESIGNATED port is then elected on each segment. There can only be one DESIGNATED port per SEGMENT/ |
- | * There can only be **one DESIGNATED port per SEGMENT/ | + | * Any port that is not DESIGNATED or a ROOT port, is then set to a BLOCKING state. |
- | * Any port that is **not** **'' | + | Note that once a ROOT Bridge is elected, all other bridges will only forward HELLO BPDU's originating from the ROOT BRIDGE. The Root cost is incremented as the HELLO BPDU is received (COST=$COST+$PORT_COST). The Root Cost starts off @ 0 from the ROOT. Each subsequent Bridge tacks on it's COST TO THE ROOT BRIDGE as it is **received**. |
- | Note that once a ROOT Bridge is elected, all other bridges will only forward HELLO BPDU' | + | |
Line 14: | Line 13: | ||
* --COST IS SAME: Is my my Bridge ID lower? | * --COST IS SAME: Is my my Bridge ID lower? | ||
* --if NO to either, PORT WILL BE BLOCKED! | * --if NO to either, PORT WILL BE BLOCKED! | ||
- | |||
- | ==PORT COSTS== | ||
- | * **10Mb link:** **'' | ||
- | * **100Mb link:** **'' | ||
- | * **1Gb Link:** **'' | ||
=====COMMANDS: | =====COMMANDS: |